Background:
3x Linn Majik amps, custom built monitors, custom active x-over.
Question:
The Majik manual warns against using the gain controls without Linn Aktiv cards fitted, but is it because the amp might be harmed (?) or because Linn are concerned about inappropriate use leading to sub standard performance?
Why the question?
In building the above mentioned x-over, I would usually include channel gain adjustment inside the x-over itself. However, it would be convenient and perhaps better sounding if I could omit that circuit, and instead use the existing controls on the amps themselves. On the other hand, I don't want to risk hurting the amps.
3x Linn Majik amps, custom built monitors, custom active x-over.
Question:
The Majik manual warns against using the gain controls without Linn Aktiv cards fitted, but is it because the amp might be harmed (?) or because Linn are concerned about inappropriate use leading to sub standard performance?
Why the question?
In building the above mentioned x-over, I would usually include channel gain adjustment inside the x-over itself. However, it would be convenient and perhaps better sounding if I could omit that circuit, and instead use the existing controls on the amps themselves. On the other hand, I don't want to risk hurting the amps.