Quantcast
Channel: Linn Forums - All Forums
Viewing all 14025 articles
Browse latest View live

Roon sounds worse than Tidal?

$
0
0
I would like a clarification from Linn development team on the following.
Me and another Linnie confirmed that Tidal streamed though Roon sound slightly inferior to Tidal directly.

Is there any difference in clocking of the audio stream through raat vs normal streaming?

I tried massive attack. Singles 90-98 and the track sly.

Roon sounds a little more confused compared to streaming from tidal directly. Is this imagination or is there any reason this could happen?

If yes. Is this expected?
Is it something Linn can "Fix" in a later update, like the airplay improvement when we went from remote clocking to internal reflecting?

I have a KDSM/2 and use analog output to K320+345?
Is there a diff[/u]erence between Exakt and Analouge how raat data is handled?

Thanks for any reply or anyone else noticing a similar difference.

New case for ADSM

$
0
0
I have bought a used ADSM with some slight scratches on the case so I would like to change the case for my ADSM ( a black one from 2012 ). Does someone know the price or is it possible to repair ?

thanks for your support Smile

No Play/Pause/Skip in Kazoo - Help....

$
0
0
I have a Majik DS and Exotik pre-amp. I purchased a data cable (from flashback) specifically for Linn RS232 so I can control the volume of the Exotic from Kazoo. Plugged it in a set the preamp in Linn Konfig Accurate, no Exotic option but I believe the Exotic is basically an Accurate. Did the reboot and in Kazoo I can now control the volume but the play / pause / skip buttons are now greyed out so I can't skip, pause, etc. in Kazoo.

Please help. It's not that cable as that's working. I don't understand why Kazoo has disabled the controls for the DS now.

Going Aktiv increases sound level?

$
0
0
I've been fortunate enough to get a pair of Katans plus 2 stereo Aktiv cards for my LK85s at a very reasonable price. I set them up first as Passive Bi-wired just to compare them to my previous Celestion 100s (not that different at modest levels), then put the Aktiv cards into the LK85s and reconfigured the speakers accordingly.
Apart from an immediately livelier sound I also noticed that I was getting previous output volumes but at a lower pre-amp setting.
Is this an expected feature, and if so, is it down to the Aktiv cards themselves, or that the internal speaker crossovers required more driving - or something else?
If anyone knows the technical answer(s) it would be interesting to hear, but for now I'll just enjoy the really pleasant sound...
Regards

Where to put some money into my LP12

$
0
0
Hi,

I own an LP12 with an early serial number, something like 157--, i believe its mid 1970's. The plinth is fluted Afromosia in excellent condition. Tonearm is an Ittok LVII with an Audio Technica AT33PTG/II low-output moving coil cartridge. Power supply is a Lingo 3 which was installed 2 years ago by my Linn dealer. I plan on visiting my dealer with my LP12 in the next month or so. Some ideas I had were, Cirkus bearing. I'm pretty sure mine doesn't have it but my dealer will be able to tell. A new sub-chassis, maybe a Majik? My budget is $500-$1000. I know the Kore is $1200, from what I was quoted. I also asked my dealer about plinths and he said usually he changes them if one is ancient or badly damaged. Just looking for some ideas from you guys on where to begin.

Thank you

Pronto help

$
0
0
Reserecting an old pronto, does anyone know how to get it connected to WiFi, I have tried all in the editor, but just won’t connect.

Katan Stands?

$
0
0
Does anyone know of anywhere in the UK still selling theses or had any success with an alternative. They seem to have become v scarce on ebay recently Sad

LP12 - Good or better ?! / True or false :) just different...hmm!?

$
0
0
*Late precirkus vs cirkus?

* Old turretnut vs new?

* Grey T-cable vs Mogami?

* Lid on/off?

* Trampolin 1 vs Trampolin 2?

* Lejonklou Power One cable om Lingo 1!




Well, what do you think/prefer and why!?
Please help me with more comparisons!!![/size]

subwoofer rca connections

$
0
0
Hi everybody.
As I bought a subwoofer recently, i have a question about the connection of it. I want to connect it low level (with rca). My adsm has two pre-amp outputs (variable). Is it ok that the output is variable or does it has to be a fixed output. What about GAIN settings on the sub when conected to a variable output on the preamp?
What should happen if the sub is connected to a fixed output ? (not the case here, just to know)

Majik 140 Speakers

$
0
0
Im considering a change of speakers to fill a gap - the bottom end.

Currently, i'm running 109's Exakt'd with a Majik Exaktbox and Akurate Exakt DSM

The obvious option being 140's, given i have the Exaktbox-i with 8 channels ava, and i like the 109 sound alot.

The problem, the speakers will need to be fairly close to the front wall, can probably allow 10cm say (which i know isn't great!). Presume i would use the foam bungs and being Exakt'd and SO - the closeness of the wall might be ok?

My room is 5meters deep and 4meters wide, but suspended floor.


thoughts??

my other options.

Series 5 speakers 520/530 and sell the Exaktbox-i
or
add an Exaktsub box and something like a Majik or Akurate sub S/H

Munich High End Show 2018

Inner platter diameter consistency

$
0
0
Hi,

Just finished replacing a customer's LP12 old bearing and inner platter with a new Cirkus bearing kit and lo and behold the outer platter does not fit on top of the new inner platter. Sad

Has anyone seen this before?

.jpg  Platter.jpg (Size: 32.43 KB / Downloads: 0)

Replacing cartridge for LP12

$
0
0
Hi there,

I inherited an LP12 from my uncle about a year ago - it's quite an old thing and the stylus in the Ortofon cartridge has completely worn out, so I'm looking at replacing it.

Took to the internet to look at new moving coil cartridges and I'm getting prices from £100-1000+, and as a student most of it is just completely out of my price bracket for the foreseeable future.

I'm wondering what you'd suggest here for a decent, good-value option, so I can get playing records again. Feel very lucky to have such a premium turntable, but seems that when things go wrong I just can't afford the mainstream replacement options!

Many thanks,
Dan

Munich High-End 2018

$
0
0
Why is Linn not attending this show?

Headshell lines Ittok LVII

$
0
0
Hey,

I have a previous thread going re: changing the cartridge but this has become more of a troubleshooting concern!

I'm currently changing the cartridge on my LP12/Ittok LVII and noticed on removing the old cartridge that the headshell wiring solder looked a bit dodgy (maybe a home job by its previous owner). I had a little screwdriver I was using to press the wires in/out and gave a prod to the green wire... which proceeded to fall off.

Is it as simple as
1) Get a soldering iron
2) re-heat solder or add another blob
3) press wire back into clip
4) tweeze cartridge-side wires back into the new cartridge
5) re-align etc, and play

???

Thanks,
Dan

ADSM connect to CEC TL3N transport

$
0
0
Hi All,

I send my ADS2 to Linn to upgrade to ADSM, I’m consider to connect CD transport to ADSM via SPDIF. Will the Katalyst DAC better than my 10 Year’s old CEC DAC DX71MK2

Roon 1.5

$
0
0
Hi Folks, I see the Kazoo app had a recent version bump, I thought this was support for Roon, however this morning I started a free 14 trial or Roon and it's not picking up my Akurate as a device, I can only Airplay to it....this being that case, I'll likley cancel Roon. Anyone else got it working?

MQA core decoding in software...Linn DS

Profound thoughts from the year of our Lord 1697

$
0
0
As William Congreve wrote in The Mourning Bride, 1697:

Musick has Charms to sooth a savage Breast,
To soften Rocks, or bend a knotted Oak.
I've read, that things inanimate have mov'd,
And, as with living Souls, have been inform'd,
By Magick Numbers and persuasive Sound.




Jeepers, I feel that way every time I crank up my LP12...

[Image: attachment.php?aid=12347]


.jpg  DSC_0034 (4).JPG (Size: 1.17 MB / Downloads: 78)

Linn Lingo 4 - noisy motors?

$
0
0
Anybody experienced issues with noisy motors with the new Lingo 4?

Does it go away with time ?
Viewing all 14025 articles
Browse latest View live


<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>